Jump to content
Sign in to follow this  
Thom Servo

K-Turn & asteroids

Recommended Posts

Here'a discussion that happened recently.

 

When you're planning on executing a K-turn but you land on an asteroid at the end of the template. Do you still execute the turn?

Edited by Thom Servo

Share this post


Link to post
Share on other sites

Yes. You execute the maneuver normally, ending on the obstacle.

 

Note that this is different than overlapping another ship in which you treat the maneuver as a straight rather than completing the k-turn.

Share this post


Link to post
Share on other sites

If I know I am going to overlap an asteroid and I will do a k-turn the following turn, I usually accelerate the process and k-turn over the asteroid. You are going to lose the action so why not take stress so it is less of a "heartache" from losing the action. 

Share this post


Link to post
Share on other sites

Played a game last night where someone tried to 4 k-turn a Firespray, hoping for a range 1 rear weapon arc shot.  He clipped me, and wound up caught on me, unable to shoot (at that particular ship), turned his 4k into a (almost) 4-forward, still had to take the stress token from the red maneuver.

Now if my ship had been an asteroid, he would have done the 4k, but been stuck on the asteroid, unable to shoot until he was off the rock, and would have had to roll 1 attack die to see if he actually collided with it.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...